Use this bar to show information about your cookie policy.
Description
MM-8G Mix & Match Cable for 600W Non-CHIRP Transducers
Mix and Match 600W transducers are made as a common base transducer with a short (2m) cable attached, plus an interchangeable longer (8m) brand-specific adapter cable.
The short pigtail attached to the transducer ends in an Airmar 5-pin female connector. The adapter cables have a matching Airmar 5-pin male connector (shown below) at one end and the correct connector for a specific brand of electronics at the other end.
Both parts are needed for installation. If the user changes equipment brand at some later time, the transducer can be left in place and the adapter cable replaced.
Mix and Match 600W transducers include the B117, B45, B60, P319, P66*, P79, SS505, and SS60. (* not all models)
A 12m (40') extension cable (part MM-5P-5P) is available with one male and one female 5-pin connector.
Note that 600W Mix and Match cables cannot be used with 1kw transducers.
This product may not be returned to the original point of purchase. Please contact the manufacturer directly with any issues or concerns.
So much better than the rubber ones I took off, easy install!
Spreader Boots
Daz Jensen
Where Have You Been All My Boating Life?
What a great little piece of tech - I don't know how we got by without it in the past. No more guessing how full the holding tank is or having to clean icky tank senders. This little bluetooth RADAR sending unit mounts on top of the tank and connects wirelessly to our Victron Cerbo.
Setup is super easy, push the button on the unit so it can calibrate to the tank then enable bluetooth and set up your rank dimensions on your Cerbo. It's as easy as that.
We've had it installed and running for about two weeks now and couldn't be more pleased (We like it enough that I ordered a second one for our water tank.)
