Use this bar to show information about your cookie policy.
Description
MM1-DST-10F Mix and Match™ Furuno 10-Pin Cable
Mix and Match 1kW transducers are made as a common base transducer with a short (2m) cable attached, plus an interchangeable longer (8m) brand-specific adapter cable. The short pigtail attached to the transducer ends in an Airmar 9-pin male connector. The adapter cables have a matching Airmar 9-pin female connector at one end and the correct connector for a specific brand of electronics at the other end.
Both parts are needed for an installation. If the user changes equipment brand at some later time, the transducer can be left in place and the adapter cable replaced.
Note: 1kW Mix and Match cables cannot be used with 600W transducers or CHIRP transducers.
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.
So much better than the rubber ones I took off, easy install!
Spreader Boots
Daz Jensen
Where Have You Been All My Boating Life?
What a great little piece of tech - I don't know how we got by without it in the past. No more guessing how full the holding tank is or having to clean icky tank senders. This little bluetooth RADAR sending unit mounts on top of the tank and connects wirelessly to our Victron Cerbo.
Setup is super easy, push the button on the unit so it can calibrate to the tank then enable bluetooth and set up your rank dimensions on your Cerbo. It's as easy as that.
We've had it installed and running for about two weeks now and couldn't be more pleased (We like it enough that I ordered a second one for our water tank.)
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.
