Use this bar to show information about your cookie policy.
Description
8068 DC 13 Position Toggle Branch Circuit Breaker Panel - White Switches
Features:
All positive, negative and grounding buses installed, fully pre-wired
Includes set of 30 common DC labels
Label backlighting pre-installed
All LEDs installed
Detailed installation instructions and cutout template
8028, 8-16 Volt DC Micro Voltmeter
8041, 0-50 Amp DC Micro Ammeter
10 15A Single Pole Circuit Breakers
Toggle Branch Circuit Breaker Panel
Specifications:
Positions: 13
Nominal Voltage: 12v DC
Maximum Amperage: 50A
Height: 7.5"
Width: 10.5"
Depth: 3"
Weight: 4.2 lbs
Included:
(10) 7210 A-Series White Toggle Circuit Breaker - Single Pole 15A
(1) 8030 Basic DC Panel Label Set - 30 Labels
(1) 8028 DC Micro Voltmeter - 8 to 16v DC (Meter)
(1) 8041 DC Micro Ammeter - 0 to 50A w/ Shunt (Meter)
WARNING: This product can expose you to chemicals including di(2-ethylhexyl)phthalate (dehp) which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.
No issues with install and regulator installation.
At first has some rpm reading issue but it was easily fixed by tweaking min duty setting thanks to the support team at yacht rigger.
Installed with an APS alternator.
ARCO Zeus Alternator Regulator- Standard
Tom in Oxford
Lugs .... but more
While the review is for lugs, its actually for a lot more than that. I upgraded from AMGs to new lithium batteries. I bought these 4/0 lugs but also the 4/0 cables, fuses, cable shrink wrap and more. Basically everything I needed for the project. A huge shout out to the Yacht Rigger as being a DYI'er there were bits and pieces I needed last minute that got shipped right away and then a few items that I swapped out. They made this super easy.
Ancor 90 Tinned Copper Lug #4/0 - 3/8" - 2-Piece
Tom in Oxford
Arco Zeus alternator regulator
After a lot of research, bought two of these units to go along with new Balmer XT-CR-170 alternators. Installation was a challenge but only due to having to run wires from one side of boat to the other but the support from Yacht Rigger electrical department was stellar. I had a couple of calls with Mike and he walked me through setup and configuration.
ARCO Zeus Alternator Regulator- Extended
Adam Green
Nice product for sealing cable routes on my boat
Using this for a Starlink install. Looks to be easy to use and effective in keeping water out of the hole for the cable.
Super high quality products! Easy to install with the easy-to-follow instructions and expert guidance from The Yacht Rigger. (Be sure to turn the shore power off and unplug the cord!)