Use this bar to show information about your cookie policy.
Description
8080 Single Circuit ON/OFF - Plus Main
Installed Components:
2 6006 m-Series Switches
1 100A c-Series Flat Rocker Circuit Breaker
Features:
Isolates batteries and provides DC main circuit protection
Ignition protected - Safe for installation aboard gasoline powered boats
Isolates the Engine circuit from the House circuit
Simplifies battery switch operation
Protects electronics from sags and spikes caused by engine cranking
Discharges batteries independently
Addition of an Automatic Charging Relay automates charging of both batteries
Enables a failed Start battery to be isolated from the electrical system and both House and Start loads to be operated from the remaining battery bank
Provides main circuit protection for DC House power system
Enables a failed House or Start battery bank to be isolated from the electrical system and both House and Start loads to be operated from the remaining battery bank
Simplifies battery switch operation
Isolates Start circuit from House circuit
Protects electronics from sags and spikes caused by engine cranking
Ignition protected - Safe for installation aboard gasoline-powered boats
Addition of an Automatic Charging Relay automates charging both batteries
Allows independent battery discharge
WARNING: This product can expose you to chemicals including di(2-ethylhexyl)phthalate (dehp) which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.
While the review is for lugs, its actually for a lot more than that. I upgraded from AMGs to new lithium batteries. I bought these 4/0 lugs but also the 4/0 cables, fuses, cable shrink wrap and more. Basically everything I needed for the project. A huge shout out to the Yacht Rigger as being a DYI'er there were bits and pieces I needed last minute that got shipped right away and then a few items that I swapped out. They made this super easy.
Ancor 90 Tinned Copper Lug #4/0 - 3/8" - 2-Piece
Tom in Oxford
Arco Zeus alternator regulator
After a lot of research, bought two of these units to go along with new Balmer XT-CR-170 alternators. Installation was a challenge but only due to having to run wires from one side of boat to the other but the support from Yacht Rigger electrical department was stellar. I had a couple of calls with Mike and he walked me through setup and configuration.
ARCO Zeus Alternator Regulator- Extended
Adam Green
Nice product for sealing cable routes on my boat
Using this for a Starlink install. Looks to be easy to use and effective in keeping water out of the hole for the cable.
Super high quality products! Easy to install with the easy-to-follow instructions and expert guidance from The Yacht Rigger. (Be sure to turn the shore power off and unplug the cord!)
SmartPlug 50 AMP Stainless Steel Combo Kit
Jay P
Great, but
A great , well made, product. Unfortunately, for the average piece of electronics, there is not enough room for the number and size of wire and connectors to pass thru the case into the rail. Photo of blank instrument panel and mount.