Featuring a SiO2+ graphene structure, this easy-to-use sealant provides ultra-durable hydrophobics and a high gloss, super slick finish to a variety of automotive exterior surfaces.
No. 100 Beadcoat SiO2 + Graphene Spray Sealant quickly provides ultra-durable hydrophobics + a high gloss, super slick finish to a variety of automotive exterior surfaces. Featuring a functional ceramic-graphene resin structure, this easy-to-use formula provides 6+ months of stand-alone paint protection and UV/detergent-resistant shine. Beadcoat can also be used to enhance & preserve an existing ceramic or graphene coating. Safe for paint, glass, wheels & trim.
Features:
Available in 16 fl oz
Average Spread/Coverage: 600-1,000 sq ft
TIPS: Always test the product first in a small, inconspicuous area to ensure the desired result. *For optimal bond/protection, ensure the surface is free of above-surface contamination; this can be achieved with iron remover + clay process (towel or bar). Below-surface paint imperfections (swirls/ scratches/marring) should be removed by DA Polish (e.g. Collinite’s No. 390)
As a lubricating drying aid: Following a wash while the vehicle surface is still wet-apply 2 sprays of Beadcoat to one 3×3 ft panel at a time. Using a microfiber towel, wipe the entirety of the panel until dry. Flip towels as necessary, and change towels as they become saturated. Repeat the process on all painted surfaces (and glass). *This process is only recommended if a previous base coat of Beadcoat has been applied.
Use:
6+ months of stand-alone paint protection
Extreme hydrophobic beading effect
Applied over ceramic coatings, paint protection film
For paint, glass, wheels, exterior trim
Easy wipe on-wipe off high gloss shine
Drying aid (once a base layer is applied)
UV and detergent-resistant
Not For Use On:
Removal of surface defects (swirls, scratches)
Not for use on contaminated surfaces; untreated by iron (chemical) or clay (mechanical) processes
So much better than the rubber ones I took off, easy install!
Spreader Boots
Daz Jensen
Where Have You Been All My Boating Life?
What a great little piece of tech - I don't know how we got by without it in the past. No more guessing how full the holding tank is or having to clean icky tank senders. This little bluetooth RADAR sending unit mounts on top of the tank and connects wirelessly to our Victron Cerbo.
Setup is super easy, push the button on the unit so it can calibrate to the tank then enable bluetooth and set up your rank dimensions on your Cerbo. It's as easy as that.
We've had it installed and running for about two weeks now and couldn't be more pleased (We like it enough that I ordered a second one for our water tank.)
Lots of wiring - no leaks! Be sure to run ALL the wires through BEFORE completing the run!
Seaview White Plastic Vertical Cable Seal f/Multiple Wires Up to 10.6mm/0.5"
Ari Storch
"Currently" super happy.
Installed on Yanmar 4JH57 engines with Zeus Controllers - HOLY WOW power. Losing some power at top end but overall very satisfied. Will do a long term review later. Talk about power - hope to never need my generator again!
