Use this bar to show information about your cookie policy.
Description
Ultima Bilge Pump UltimaBilge Pumps are the latest addition to the Johnson Pump brand lineup. Integration of the Ultima "field effect" sensing technology into the bilge pump body creates a sleek, reliable and compact unit with integrated switch ready to install and run for years and years of unerring service. Available in 600-800-1000-1250 GPH versions. Voltage 12 V DC. For UltimaBilge 600 GPH-1000 GPH, we have easy-to-install Dura-Port discharge ports to eliminate stress cracking caused by over-tightened hose clamps. These pumps will be delivered including both a straight and a 90 degree smooth elbow Dura-Port.
All version are delivered with a removable check valve.
The Ultima Bilge pumps may be manually operated via the Johnson Pump bilge control panel. CE-Approved
Features:
Compact, all-in-one unit
Integrated Ultima Switch sensing right into the pump body
No Mercury
Removable clip on basket design
Removable impeller cover allows for easy clean out
3-wire device can be run in auto or manual override mode
No tools needed for maintenance
Extremely energy efficient
Water-cooled motor for long service intervals
Meets the international standard, ISO 8849 marine
Pump Body: ABS
Shaft Seal: Lip Seal
Shaft: Stainless steel
Voltage: 12 V DC
Capacity 3 ft (0.9 m) head (13.6 V): 38 l/min - 600 GPH
No issues with install and regulator installation.
At first has some rpm reading issue but it was easily fixed by tweaking min duty setting thanks to the support team at yacht rigger.
Installed with an APS alternator.
ARCO Zeus Alternator Regulator- Standard
Tom in Oxford
Lugs .... but more
While the review is for lugs, its actually for a lot more than that. I upgraded from AMGs to new lithium batteries. I bought these 4/0 lugs but also the 4/0 cables, fuses, cable shrink wrap and more. Basically everything I needed for the project. A huge shout out to the Yacht Rigger as being a DYI'er there were bits and pieces I needed last minute that got shipped right away and then a few items that I swapped out. They made this super easy.
Ancor 90 Tinned Copper Lug #4/0 - 3/8" - 2-Piece
Tom in Oxford
Arco Zeus alternator regulator
After a lot of research, bought two of these units to go along with new Balmer XT-CR-170 alternators. Installation was a challenge but only due to having to run wires from one side of boat to the other but the support from Yacht Rigger electrical department was stellar. I had a couple of calls with Mike and he walked me through setup and configuration.
ARCO Zeus Alternator Regulator- Extended
Adam Green
Nice product for sealing cable routes on my boat
Using this for a Starlink install. Looks to be easy to use and effective in keeping water out of the hole for the cable.
Super high quality products! Easy to install with the easy-to-follow instructions and expert guidance from The Yacht Rigger. (Be sure to turn the shore power off and unplug the cord!)
