Use this bar to show information about your cookie policy.
Description
Standard Performance Series Tabs
Standard actuator with 5/16" stainless steel through bolts. 1" turned up edges with 2" taper on the inside. All 12-gauge 304 stainless steel construction with Electro-Polished Blades
We make the best boats better!
Running wide open in rough seas isn't for the faint of heart. Aggressive boating requires durable boat accessories. Lenco's Standard Performance series of trim tabs are built to handle whatever you or Mother Nature might throw at them. Everything about your boat is designed to go hard and fast. Why should your trim tab system be any different?
All stainless steel construction (no dissimilar metals), Electro Polished Blades for long lasting good looks
Actuator speed is precise and controllable so there are no surprises at top speeds
Actuators
Instant response
Fully submersible, maintenance-free and sealed for life
High-impact, 50% glass fiber-filled, ultraviolet-resistant nylon case
Tactile Switch w/ Indicator LED for all Single Actuator Trim Tab Systems Features:
Self-contained, sealed keypad
Self-contained, sealed control box module
Fade/smudge-proof, laser engraved graphics
Plug & play switch wiring harness connector
Includes 36" power pigtail for control box
2" hole cut-out size, overall size 2.75" x 2.75"
Built-in retract feature returns tabs to a fully retracted position when power is removed
2 high-intensity L.E.D. indicator displays show the exact position of our trim tabs at all times
Photo eye reads ambient light and adjusts the L.E.D. indicator display intensity for optimum viewing in direct sunlight
12 & 24-volt compatibility
Includes Self-Check Feature
Each kit contains:
Tactile LED Indicator Switch Kit
2 actuators with 6' Lead & Deutsch Plugs
2 12 Gauge SS Electro Polished trim tab planes
2 20' Actuator Extension Wiring Harness
2 Upper Mounting Bracket with Gland Seal
2 Lower Mounting Bracket
All Necessary stainless steel mounting Hardware
WARNING: This product can expose you to chemicals including di(2-ethylhexyl)phthalate (dehp) which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.
This product may not be returned to the original point of purchase. Please contact the manufacturer directly with any issues or concerns. Brochure (pdf)
No issues with install and regulator installation.
At first has some rpm reading issue but it was easily fixed by tweaking min duty setting thanks to the support team at yacht rigger.
Installed with an APS alternator.
ARCO Zeus Alternator Regulator- Standard
Tom in Oxford
Lugs .... but more
While the review is for lugs, its actually for a lot more than that. I upgraded from AMGs to new lithium batteries. I bought these 4/0 lugs but also the 4/0 cables, fuses, cable shrink wrap and more. Basically everything I needed for the project. A huge shout out to the Yacht Rigger as being a DYI'er there were bits and pieces I needed last minute that got shipped right away and then a few items that I swapped out. They made this super easy.
Ancor 90 Tinned Copper Lug #4/0 - 3/8" - 2-Piece
Tom in Oxford
Arco Zeus alternator regulator
After a lot of research, bought two of these units to go along with new Balmer XT-CR-170 alternators. Installation was a challenge but only due to having to run wires from one side of boat to the other but the support from Yacht Rigger electrical department was stellar. I had a couple of calls with Mike and he walked me through setup and configuration.
ARCO Zeus Alternator Regulator- Extended
Adam Green
Nice product for sealing cable routes on my boat
Using this for a Starlink install. Looks to be easy to use and effective in keeping water out of the hole for the cable.
Super high quality products! Easy to install with the easy-to-follow instructions and expert guidance from The Yacht Rigger. (Be sure to turn the shore power off and unplug the cord!)