Use this bar to show information about your cookie policy.
Description
RAM Mount Universal X-Grip Holder Yoke Glare Mount Part #: RAP-B-121-UN7U
RAM Composite Clamp Mount with Universal X-Grip Holder. Rubber ball and socket technology allows for almost infinite adjustment and perfect viewing angles. High quality composite materials insure your device is safe, secure, and within easy reach. The clamp base fits a rail or edge lip from 0.625" to a maximum of 1.25". The mounting base can also accept a second ball giving you the ultimate double ball base. Extra ball not included with purchase of this mount.
Compatible Devices: Apple iPhone 4S WITH OR WITHOUT Bumper, Skin or Case Apple iPhone 4 WITH OR WITHOUT Bumper, Skin or Case Apple iPhone 3G WITH OR WITHOUT Bumper, Skin or Case Apple iPhone 3 WITH OR WITHOUT Bumper, Skin or Case Apple iPhone (1st Generation) Apple iPod touch (All Models) Apple iPod (G1-G5)
All devices that maintain the following dimensions below:
Holder Dimensions: Minimum Width = 0.875" (Devices at 0.875" must be a minimum of 4" in height to fit into holder) Maximum Width = 3.25" Depth = 0.875"
Features: 1. Spring loaded holder expands and contracts for perfect fit of your device 2. Rubber coated tips will hold device firm and stable 3. Versatility of holder allows for attachment to many RAM-to-RAM ball mounts 4. Single socket technology allows for multiple adjustment angles and articulation of device
No issues with install and regulator installation.
At first has some rpm reading issue but it was easily fixed by tweaking min duty setting thanks to the support team at yacht rigger.
Installed with an APS alternator.
ARCO Zeus Alternator Regulator- Standard
Tom in Oxford
Lugs .... but more
While the review is for lugs, its actually for a lot more than that. I upgraded from AMGs to new lithium batteries. I bought these 4/0 lugs but also the 4/0 cables, fuses, cable shrink wrap and more. Basically everything I needed for the project. A huge shout out to the Yacht Rigger as being a DYI'er there were bits and pieces I needed last minute that got shipped right away and then a few items that I swapped out. They made this super easy.
Ancor 90 Tinned Copper Lug #4/0 - 3/8" - 2-Piece
Tom in Oxford
Arco Zeus alternator regulator
After a lot of research, bought two of these units to go along with new Balmer XT-CR-170 alternators. Installation was a challenge but only due to having to run wires from one side of boat to the other but the support from Yacht Rigger electrical department was stellar. I had a couple of calls with Mike and he walked me through setup and configuration.
ARCO Zeus Alternator Regulator- Extended
Adam Green
Nice product for sealing cable routes on my boat
Using this for a Starlink install. Looks to be easy to use and effective in keeping water out of the hole for the cable.
Super high quality products! Easy to install with the easy-to-follow instructions and expert guidance from The Yacht Rigger. (Be sure to turn the shore power off and unplug the cord!)
