Receive News, product promotions & gifts
Use this bar to show information about your cookie policy.
Rule-Mate 2000 GPH 12 Volt Fully Automated Bilge Pump
The Rule-Mate® 2000 GPH pump consists of a powerful Rule® bilge pump and a highly intelligent circuit board in a single housing. The pump activated when the water reaches 2-1/2" and automatically shuts off when the pump senses no water against the impeller, reducing the remaining water to approximately 5/8".
Rule-Mate Intelligence
Rule-Mate Bilge pumps have built-in programming that can sense when the pump is running but not pumping water. This is a very unique feature to bilge pumps because it protects the pump and the vessel, especially the vessels batteries. If debris fouls the sensor or the pump becomes air-bound, the pump will stop running and begin to "check" for water every 2-1/2 minutes. Once the debris is removed, the pump will revert to its normal operation, turning on when the water reaches 2-1/2" and shutting off at 5/8".
WARNING: This product can expose you to chemicals including FORMALDEHYDE (GAS) which is known to the State of California to cause cancer. For more information go to P65Warnings.ca.gov.
Specifications:
Sign up for monthly news and promotions
200 14th Avenue Southeast, St. Petersburg, FL 33701
7C San Bartola Drive, Saint Augustine, FL 32086




What a great little piece of tech - I don't know how we got by without it in the past. No more guessing how full the holding tank is or having to clean icky tank senders. This little bluetooth RADAR sending unit mounts on top of the tank and connects wirelessly to our Victron Cerbo.
Setup is super easy, push the button on the unit so it can calibrate to the tank then enable bluetooth and set up your rank dimensions on your Cerbo. It's as easy as that.
We've had it installed and running for about two weeks now and couldn't be more pleased (We like it enough that I ordered a second one for our water tank.)
Lots of wiring - no leaks! Be sure to run ALL the wires through BEFORE completing the run!
Installed on Yanmar 4JH57 engines with Zeus Controllers - HOLY WOW power. Losing some power at top end but overall very satisfied. Will do a long term review later. Talk about power - hope to never need my generator again!
We bought these boots in 2022, and are buying new ones 3 years later. We love the design and the fact that they are easy to remove for inspection of the rig.
Review for electrical system components:
• Victron Lithium Battery 24VDC 300Ah NG Smart LifePO4 (x4)
• Victron Lynx Smart BMS 500 NG (M10)
• Victron Lynx Distributor w/M10 Terminals (x2)
• Victron MultiPlus-II 24/5000 120-95 120V (x2)
• Victron Phoenix Smart IP43 Charger 24/25 (1+1) 120-240VAC (x5)
• Victron Cerbo GX MK2 w/ Victron GX Touch 70 Flush Mount Display
• Z Bar - Class T battery link Bundle w/ Blue Sea 5119 300AMP Class T Fuse (x4)
• Victron Orion XS 1400 DC-DC Battery Charger (x2)
• Victron SmartSolar MPPT Charge Controller - 100V - 30AMP - UL Approved (x4)
Complete upgrade of my Irwin 54 Sloop electrical system –
Phase 1 – Remove 9KW generator, install 30KW LifePO4 battery system, inverter chargers, battery chargers, etc. wired for worldwide shore power capability to ABYC standards. Installation made possible with guidance and support from Andre Cormier and The Yacht Rigger.

