Use this bar to show information about your cookie policy.
Description
Galaxy® Style 5228 8' Heavy-duty Extension Mast
Constructed of high-quality Shakespeare white fiberglass, and finished to match Galaxy antennas. This 1-1/2" diameter extension mast can be used to increase height of an antenna and thus improve effective range, or to boost placement of an antenna above on-board obstructions.
IMPORTANT! If the combined length of your antenna and all extensions is more than 8', users MUST use an upper support bracket
Features:
Reduced length version
Stainless steel upper and lower ferrules with standard 1" - 14 thread
Mount: A Style 409-R or 410-R Mounting Kit is required
No issues with install and regulator installation.
At first has some rpm reading issue but it was easily fixed by tweaking min duty setting thanks to the support team at yacht rigger.
Installed with an APS alternator.
ARCO Zeus Alternator Regulator- Standard
Tom in Oxford
Lugs .... but more
While the review is for lugs, its actually for a lot more than that. I upgraded from AMGs to new lithium batteries. I bought these 4/0 lugs but also the 4/0 cables, fuses, cable shrink wrap and more. Basically everything I needed for the project. A huge shout out to the Yacht Rigger as being a DYI'er there were bits and pieces I needed last minute that got shipped right away and then a few items that I swapped out. They made this super easy.
Ancor 90 Tinned Copper Lug #4/0 - 3/8" - 2-Piece
Tom in Oxford
Arco Zeus alternator regulator
After a lot of research, bought two of these units to go along with new Balmer XT-CR-170 alternators. Installation was a challenge but only due to having to run wires from one side of boat to the other but the support from Yacht Rigger electrical department was stellar. I had a couple of calls with Mike and he walked me through setup and configuration.
ARCO Zeus Alternator Regulator- Extended
Adam Green
Nice product for sealing cable routes on my boat
Using this for a Starlink install. Looks to be easy to use and effective in keeping water out of the hole for the cable.
Super high quality products! Easy to install with the easy-to-follow instructions and expert guidance from The Yacht Rigger. (Be sure to turn the shore power off and unplug the cord!)
